濱州力士樂伺服驅動器維修：F629 Positive Travel Limit Value is Exceeded超過正行程限值。。The drive has been provided with a command value that leads to an axis position outside the positive travel range.為驅動器提供了一個指向軸的命令值位置在正行程范圍之外。
The axis has been stopped andthe error reaction "set velocity command value to zero" issued. Bit 2 of P-0-0090, 軸已停止，并發出錯誤反應“將速度命令值設置為零”。P-0-0090第2位
Travel limit parameter has been set to "Exceeding the travel limit is an error", or a drive control command has been started while theaxis limit value is exceeded (e.g. drive-controlled homing).行程限制參數已設置為“超過行程限制是一個錯誤”，或者在超過軸限制值時啟動了驅動控制命令（例如，驅動控制歸位）。
Cause:原因：
S-0-0049, Positive position limit value is exceeded.
S-0-0049，超過正位置限值。
Remedial action:補救措施：
1. Check S-0-0049, Positive position limit value
檢查S-0-0049，正位置限值
2. Check the controller software limits
檢查控制器軟件限制
3. Activate the axis after the error reaction
錯誤反應后激活軸
Procedure:程序：
• Clear the error
清除錯誤
• Activate power if it has been de-activated
如果電源已停用，則激活電源
• Move the axis to the permissible working range
將軸移動到允許的工作范圍
轉載請注明出處：上海仰光電子科技專業伺服驅動器維修,伺服電機維修
本文鏈接：http://m.kvp.net.cn/fuwu/Services_Show21437.htm
伺服驅動器維修 伺服電機維修 觸摸屏維修 變頻器維修
電話：021-50157782
手機：13817011982 微信同號
郵箱：[email protected]
聯系人：張工
網址：http://m.kvp.net.cn
【 我們確保修好測試好給客戶！！！！】
下一篇：東曹凝膠滲透色譜儀HLC-8321GPC常見故障維修方法
